DeWalt DCMWP134 Manual página 59

nOTE: Ensure both battery packs are fully seated and fully
latched into position before starting mower.
3. Close the battery port cover
closed before starting mower.
To Remove the Battery Packs
1. Lift and hold the battery port cover
battery port 38 .
2. Depress the battery release button
battery packs and pull the battery packs out of the
26
battery port .
38
Fuel Gauge Battery Packs (Fig. C)
Some D WALT battery packs include a fuel gauge, which
e
consists of three green LED lights that indicate the level of
charge remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge
button . A combination of the three green LED lights will
62
illuminate, designating the level of charge left. When the level
of charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be recharged.
nOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end-user application.
Safety Key (Fig. T)

DANGER: Sharp moving blade. In order to prevent
accidental start-up or unauthorized use of your cordless
mower, a removable safety key has been incorporated into
the design of your mower. The mower will be completely
disabled when the safety key has been removed from
the mower.

DANGER: Rotating blades can cause serious injury.
To prevent serious injury, turn unit off and remove
safety key and battery packs when unattended, or when
charging, cleaning, servicing, transporting, lifting, or
storing mower.
1. Insert safety key into the key slot
6
handle , until it is fully seated inside of the key slot
4
shown in Fig. T.
2. The mower is now operational.
Control Panel Indicators (Fig. A, U)
The control panel 12 contains the state of charge indicator,
load meter indicator, temperature indicator, handle folding
indicator, blade sharpening indicator and reset button.
State of Charge Indicator (Fig. U)
The DCMWP134 and DCMWSP156 are equipped with a state of
charge indicator. This will display the current level of charge in
the batteries during use. It does not indicate tool functionality
. Ensure the cover is fully
19
up to expose the
19
27 on the
, located on the main
50
50
and is subject to variation based on product components,
temperature and end-user application.
• The state of charge indicator LEDs
indicating the percent of charge in the batteries.
• When all 5 state of charge indicator LEDs
batteries are fully charged.
• When one state of charge indicator LED
charge is low and then it will flash when the batteries
are discharged. Remove the batteries and charge them.
State of Charge Indicator LED Status
LEVEL OF CHARGE
100% ‑ 85%
70% ‑ 85%
50% ‑ 70%
25% ‑ 50%
≤25%
Low battery shutdown
Handle Folding Indicator (Fig. U)
as
The handle folding indicator
single touch handle
position. To clear the handle folding indicator
Raise the Single Touch Handle section in this manual.
Cutting Load Meter Indicator (Fig. U)
The cutting load meter indicator
yellow or red when mowing.
• White indicates a low cutting load.
• Yellow indicates a medium cutting load.
• Red indicates a high cutting load. Runtime will be reduced if
there is a prolonged high load while mowing.
will illuminate,
18
18
18
CHARGE INDICATOR
LED COLOR
White
White
White
White
White
White and blinking
will illuminate when the
15
is not engaged in the operating
1
14 will illuminate white,
EnGLIsh
illuminate, the
illuminates,
15 , refer to the
57 57