Idiomas disponibles
Idiomas disponibles
LAN Restart
Any modification on the LAN settings described above will restart the LAN after pressing Apply Changes. This feature
restarts the networking using ALL current LAN settings. LAN restart does not clear the Web Interface password.
Remote interface
LXI:REStart
LAN Services
Enables (On) or disables (Off) LAN services on the instrument.
Step
Front panel
1
Press
[Home] > User Settings > I/O > LAN Settings > LAN Services
Press On to enable or Off to disable each setting.
2
If you change this parameter, you must press
[Done] > [Apply Changes] for the change to take effect.
– Refer to the Keysight IO Libraries help for information on the VXI-11, Sockets, and HiSLIP protocols.
– Telnet - The instrument telnet port is 5024. Open SCPI sessions on the Telnet connection by entering: telnet IP
address 5024
– Web - Enable or disable instrument programming from the instrument's Web Interface.
– mDNS - mDNS service is for use in networks where no conventional DNS server is installed. Cycling power or
resetting the LAN always enables mDNS.
Set to Defaults
This feature resets the LAN settings to the respective factory default values.
Front panel
Press
[Home] > User Settings > I/O > LAN Settings > Set to
Defaults
LAN Reset
Resets the LAN using its current settings and enables DHCP mode and mDNS service. The LAN reset also clears any
user-defined Web user interface (Web UI) password.
Front panel
Press
[Home] > User Settings > I/O > LAN Reset
Keysight DAQ970A/DAQ973A User's Guide
1 Introduction to the Instrument
Remote interface
(none)
SYSTem:COMMunicate:LAN:UPDate
Remote interface
(None)
Remote interface
LXI:RESet
27
