Idiomas disponibles
Idiomas disponibles
Once DHCP is disabled, the following parameters will be available for manual setup:
–
Host Name
–
IP Address
–
Subnet Mask
–
Gateway
–
Primary and Secondary DNS
–
Primary and Secondary WINS
–
Service mDNS
Host Name
A hostname is the host portion of the domain name, which is translated into an IP address.
Step
Front panel
1
Press
[Home] > User Settings > I/O > LAN Settings > Modify Settings.
Set the first softkey to
2
If you change this parameter, you must press
[Done] > [Done] > [Apply Changes] for the change to take effect.
Each instrument is shipped with a default host name with the format: K-modelnumber-serialnumber, where
modelnumber is the instrument's 7-character model number (e.g. DAQ970A), and serialnumber is the last five
characters of the 10-character instrument serial number located on the label on the top of the unit (e.g. 45678 if the
serial number is MY12345678).
– The instrument receives a unique hostname at the factory, but you may change it. The hostname must be
unique on the LAN.
– The name must start with letter, other characters can be an upper or lower case letters, numeric digits, or
dashes "-".
– This setting is non-volatile, it will not be changed by cycling power, factory reset (*RST command), or instru-
ment present (SYSTem:PRESet command).
Keysight DAQ970A/DAQ973A User's Guide
Manual and press Host Name to enter the host name.
1 Introduction to the Instrument
Remote interface
SYSTem:COMMunicate:LAN:HOSTname
SYSTem:COMMunicate:LAN:UPDate
23
