Idiomas disponibles
Idiomas disponibles
Gateway
A gateway is a network device that connects networks. The default gateway setting is the IP address of the
instrument.
Step
Front panel
1
Press
[Home] > User Settings > I/O > LAN Settings > Modify Settings.
Set the first softkey to
gateway address.
2
If you change this parameter, you must press
[Done] > [Apply Changes] for the change to take effect.
– Do not set a gateway address when DHCP is enabled (factory default).
– Contact your LAN administrator to obtain an IP address.
– This setting is non-volatile, it will not be changed by cycling power, factory reset (*RST command), or instru-
ment present (SYSTem:PRESet command).
Primary and Secondary DNS
A DNS (Domain Name Service) is an Internet service that translates domain names into IP addresses. The DNS
server address is the IP address of a server that performs this service.
Step
Front panel
1
Press
[Home] > User Settings > I/O > LAN Settings > Modify Settings.
Set the first softkey to
to set the desired DNS address.
2
If you change this parameter, you must press
[Done] > [Apply Changes] for the change to take effect.
– Normally, DHCP discovers the DNS address information; you only need to change this if DHCP is unused or non-
functional.
– Contact your LAN administrator to obtain an IP address.
– This setting is non-volatile, it will not be changed by cycling power, factory reset (*RST command), or instru-
ment present (SYSTem:PRESet command).
Keysight DAQ970A/DAQ973A User's Guide
Manual and press Gateway to set the desired
Manual and press Primary DNS or Second DNS
1 Introduction to the Instrument
Remote interface
SYSTem:COMMunicate:LAN:GATEway
SYSTem:COMMunicate:LAN:UPDate
Remote interface
SYSTem:COMMunicate:LAN:DNS[{1|2}]
Note: The [{1|2}] syntax indicates the type of primary
(1) or secondary (2) DNS server address.
SYSTem:COMMunicate:LAN:UPDate
25
