Alarm Display For The Oil To Be Replaced; Deaeration" Display; Gas Alarm" Display; Sensor Alarm" Display - Orved Сuisson 31 Manual De Uso

9.2.4 AlARM DISPlAy fOR ThE OIl TO bE REPlACED

Once the maximum admissable number of cycles has been reached, at each start-up and at the end of every cycle, the
LEDs start to flash, which means that the oil must be replaced (vedi §9.1.1).
The alarm is reset once the oil is replaced.
ATTENTION!
If the oil change alarm has been triggered, contact your authorised after-sales centre for it to be repla-
ced.
WARNINg! The indication protects the pump from rapid deterioration due to oxidation and maintains the machine's
maximum efficiency and performance.
9.2.5 "DEAERATION AlARM" DISPlAy
In the case that during deaeration, for whatever reason, the maximum vacuum and partial vacuum values provided by
the software are not achieved, the cycle is interrupted and the vacuum chamber is decompressed.
The display shows the specific alarm.
If for the next cycle the alarm recurs, contact customer service.

9.2.6 "GAS AlARM" DISPlAy

In the case of finishing of the cylinder or where the intake pipe is blocked or crushed during a cycle that involves the
injection of gas, the machine stops that cycle and the vacuum chamber is decompressed.
The display shows the specific alarm.

9.2.7 "SENSOR AlARM" DISPlAy

In the case of vacuum sensor disconnected, blocked or defective, the machine allows operation with one of the user
programs, with the Jars No Stop cycle and with the sensor jars cycle, all in timed mode (the operating time of the vacuum
pump must therefore be set in seconds); all the pre-set and deaeration cycles are inhibited.
The display shows the specific alarm.
Rev. 01 - 03/2018 - Cod. 1500024 - Instruction manual for vacuum chamber packaging machines for vacuum cooking mod.
OPERATION
Cuisson 45