Panasonic ES-EL3A Instrucciones De Funcionamiento página 16

Charging
For best performance, fully charge the
appliance before use.
You cannot operate the appliance while
charging.
Charging time = Approx. 1 hour
The epilator can be used for
approximately 30 minutes (35 minutes
when using the gentle cap) after 1 hour
of charging.
This will differ depending on the
temperature.
Plug the AC adaptor into the
epilator ( ) and a household
outlet ( ). (Fig. 1)
Red light appears while charging. (Fig. 2)
Red light goes off after charging is
completed. (Fig. 3)
Red light blinks twice every second
when abnormal charging. (Fig. 4)
• Recommended ambient temperature for
charging is 15 °C – 35 °C. The battery
may not charge properly or not at all if
outside the recommended temperature.
• The charging time may decrease
depending on the charging capacity.
• Charging the appliance every time it is
used will not affect the life of the
rechargeable battery.
• When charging the appliance for the
first time or when it has not been in use
for more than 6 months, the charging
time may change or the charging
indication/notification light may not
glow for a few minutes. It will eventually
glow if kept connected.
• If there is noise from the radio or other
sources while using or charging the
appliance, move to a different location
to use the appliance.
<To check if charging is completed>
If you remove and reinsert the appliance
plug while charging, the charging
indication/notification light glows and
turns off after approximately 5 seconds.
16
PB015615 - EL8A-3A-2A _(01GB)_01-26-18.indd 16
Before use
Removing and attaching the
head
Remove the head while pushing
the head release button and push
the head until it clicks. (Fig. 5)
Using the bikini comb
ES-DEL8A/ES-EL8A
Place the bikini comb onto the
shaver head and slide trimmer
up. (Fig. 6)
• When the bikini comb is in place, make
sure the comb is in close contact with
the skin.
<LED light> (Fig. 7)
The LED light comes on when the
power is turned on. The light will remain
on while the power is ON.
<Mode selecting function> (Fig. 8)
• The disc rotation speed can be
switched between 3 stages. Try using
the SOFT mode when you are
concerned about irritation when
removing hairs.
• Operation will change in order from
●(SOFT) ●●(NORMAL)
●●●(POWER) "OFF" each time the
power switch is pressed.
• When using the foot care head, using
the POWER mode is recommended.
●: SOFT
The disc will rotate at a low speed.
• 1 of Mode lamps will glow blue.
●●: NORMAL
The disc will rotate at a normal speed.
• 2 of Mode lamps will glow blue.
●●●: POWER
The disc will rotate at a high speed.
• 3 of Mode lamps will glow blue.
OFF
The power will be switched OFF.
2018/1/26 13:42:33