Installation - Kostrzewa Twin Bio Manual De Uso

6. Boiler start-up, operation... | 7. Installation
Emergency stop may be caused by:
• no safety valve operation at exceeded allowable pressure;
• pressure section leakage;
• pressure section deformation;
• boiler room or auxiliary equipment explosion or fi re;
• drain valve leakage;
• safety or control device failure;
• pressure gauge failure;
• circulating pump failure;
• fl ue gas explosion;
• leakage in installation connection or welded connections
of the pressurised part;
• drain pipe blockage;
• auxiliary equipment failure;
• other faults which cannot be removed during boiler
operation due to safety or technical reasons.
Emergency procedure:
• stop the boiler immediately (use the main power switch
outside the boiler room, if required);
• use suitable fi re-fi ghting measures (extinguishers) in case
of a fi re.

7. Installation

CAUTION!!!
Install and remove boiler components if:
• boiler is stopped and cooled down;
• wiring system is disconnected;
• fuel feed system is disconnected;
• boiler control system is removed (if installed
on the side wall);
• transport and storage of boiler components
was scheduled in advance due to safety
reasons.
7.A. Insulation door installation and removal
Experts in heating
Fig. Insulation door installation and removal
User Manual Twin Bio - PLV 09.13
69