Parkside Performance PPKSA 40-Li A1 Traduccion Del Manual De Instrucciones Originales página 60

GB MT
Other diameters damage the
chain and can lead to danger
during work!
3. Sharpen only from the inside to the out-
side.­Guide­the­file­from­the­inner­side­
of the cutting teeth to the outer side. Lift
the­file­when­you­are­withdrawing­it.
4.­ Sharpen­first­the­teeth­on­one­side.­Turn­
the saw around and sharpen the teeth
of the other side.
5. The chain is worn and must be re-
placed by a new saw chain if only
approx.­4­mm­of­the­cutting­teeth­is­
remaining.
6.­ After­the­sharpening,­all­cutting­elements­
must now be equal in length and width.
7.­ After­every­third­sharpening,­the­sharp-
ness­depth­(depth­limitation)­must­be­
checked­and­the­height­filed­with­the­
aid­of­a­flat­file.­The­depth­limitation­
should be set back about 0.65 mm
from the cutting tooth. After the setting
back­of­depth­limitation,­round­it­off­a­
little at the front.
Adjusting the chain tension
The adjustment of the chain tension is de-
scribed in the chapter "Assembly - tension-
ing­chainsaw".
• Switch off the device and remove the
battery­(16)­from­the­device
• Check the chain tension regularly and
re-adjust this as often as possible.When
the saw chain is tensioned with 9 N
(approx.­1­kg),­the­gap­between­the­
saw chain and the guide rail may not
be more than 2 mm.
Starting up a new saw chain
In­the­case­of­a­new­chain,­the­tensioning­
force­decreases­after­some­time.­Therefore,­
60
you have to re-tension the chain after the
first­5­cuts­and­no­later­than­after­10­min-
utes' sawing time.
Approved saw chains:
Oregon­90PX056X,
Trilink CL14356TL
Never attach a new chain to
a worn drive pinion or place
onto a damaged or worn
chain bar. The chain could
spring back or break, poten-
tially leading to serious injury.
Maintaining the chain bar
Use cut-protection gloves
when handling the chain or
the chain bar.
1. Switch off the device and remove the
battery­(16)­before­carrying­out­any­
maintenance work.
2. Remove the sprocket chain wheel cov-
ering­(13),­the­saw­chain­(6)­and­the­
chain­bar­(7).
3.­ Check­the­chain­bar­(7)­for­wear.­Re-
move burrs and straighten the guide
surfaces­with­a­flat­file.
­ If­the­blade­bar­is­damaged,­replace­
it. Approved blade bars:
Oregon­164MLE041(112329),
Trilink M1431656-1041TL.
4. Clean the oil passages (
chain­bar,­in­order­to­29­a­trouble-free,­
automatic oiling of the saw chain dur-
ing operation.
5.­ Mount­chain­bar­(7),­chainsaw­(6)­and­
sprocket­chain­wheel­covering­(13)­
and tighten the chainsaw.
­28),­of­the­