Overview of the LED indicators on
the charger:
Green LED illuminated while battery not
inserted: Charger is ready.
Green LED lights up: Battery is charged.
Red LED lights up: Battery charging.
Red LED flashes: Overheated
Red and green LED flash:
Battery defective
Assembly
Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself – injury hazard!
Before putting the electric chain saw into
operation,youmust:
-
adjustthesawchaintension,
-
pourinchainoil,
-
charge and insert both batteries
-
check the function of the chain brake
and the automatic oil pump.
Mounting the saw chain
and blade
Switch off the device and remove
the battery before carrying out any
maintenance work.
1. Laythesawonaflatsurface.
2. Turnthefasteningbolt(11)anti-
clockwise (
sprocketchainwheelcovering(13).
3. Spreadthechain(6)outintoaloop
with the cutting edges running clock-
wise . Use the graphical symbol on the
bladeorbelowthechainsprocket(20)
asaguidetoalignthesawchain(6).
) to remove the
4. Slidethesawchain(6)intothebar
guide groove. To mount the guide bar
(4),raiseittoanangleofapprox.
45 degrees. This will make it easier
toreplacethesawchain(6)ontothe
sprocket(20).
5. Placethechainbar(7)andsawchain
(6)onthebarbolts(19).Whenthepin
(19a)totherightofthecoachscrew
(19)sitsintheslottedrecessonthe
blade,thebladeisplacedcorrectly.
Itisnormalthatthesawchain(6)is
slack.
6. Position the sprocket chain wheel cover-
ing(13).Thechaintensionerpin(21)
ontheinsideofthesprocketcover(13)
must be guided into the chain tension
pinholder(22).
7. Slightlytightenthemountingscrew(11)
of the sprocket cover (
8. Pre-tensionthesawchain(6)byturning
the screw for the chain quick-tensioning
system(12)inclockwisedirection.
9. Tightenthefasteningbolt(11)(
Note that the saw can re-oil.
Please note that the saw re-oils after use
and oil may leak out if it is stored on its
side or on the head. This is a normal
process due to the necessary ventilation
opening on the upper edge of the tank and
does not constitute a reason for complaint.
As each saw is checked during production
andtestedwithoil,asmallresiduemay
beinthetankdespitedraining,whichmay
slightly dirty the housing with oil in transit.
Please clean the housing with a cloth.
Priortochangingthechain,thenutofthe
guide rail must be cleaned of dirt because
GB
Direction of travel of the
saw chain
) .
MT
).
49