Parkside Performance PPKSA 40-Li A1 Traduccion Del Manual De Instrucciones Originales página 50

GB MT
dirt deposits available can cause the chain
to break out of the rail. The deposits can
also absorb the chain oil. So the conse-
quence would be that the chain oil would
not or only a small part of it would reach
the underside of the rail and the lubrication
would be reduced.
Tensioning the saw chain
Regularly tightening the saw chain pro-
vides safety for the user and reduces and/
or prevents wear and chain damages.
Before­the­start­of­work­and­in­approx.­10­
minute­intervals,­we­recommend­the­user­to­
examine­the­chain­tension­and­correct­it,­if­
necessary.
The chain warms up when working with
the­saw­and­thus­expands­slightly.­These­
"expansions"­can­be­expected­especially­
from newer chains.
Do not re-tighten or change the
chain when it is hot because it
shrinks slightly once it has cooled
down.­In­case­of­non-observance,­this­can­
lead to damages on the guide rail or the
engine because now the chain is too taut
on the blade. Chain tension and chain lu-
brication­have­a­significant­impact­on­the­
service life of the chain.
The chain is correctly tensioned if it does
not sag at the rail underside and can be
rotated completely around with the gloved
hand. When the saw chain is tensioned
with­9­N­(approx.­1­kg),­the­gap­between­
the saw chain and the guide rail may not
be more than 2 mm.
50
Switch off the device and remove
the battery before carrying out any
maintenance work.
­ 1.­ Ensure­that­the­chain­brake­has­
been­released,­that­is,­that­the­
chain­brake­lever­(5)­is­pulled­up­
against­the­front­grip­(4).
­ 2.­ Unscrew­the­fastening­bolt­(11)­
(
­ 3.­ To­tension­the­saw­chain,­turn­
the­screw­(12)­for­the­chain­
quick-tensioning system in
clockwise direction.
­ ­ To­loosen­the­tension,­turn­the­
screw­(12)­in­counter-clock-
wise direction.
­ 4.­ Tighten­up­the­fastening­bolt­(11)­
again (
­ With­a­new­saw­chain,­you­must­
readjust the chain tension after at
least 5 cutting operations.
Chain lubrication
The rail and chain must never be
without oil. If the cordless chainsaw
is­used­with­too­little­oil,­the­cutting­perfor-
mance and lifespan of the saw chain will
decrease as the chain will become blunt
more quickly. You can identify a case of
too little oil where smoke development or
discoloration of the rail occurs.
The chainsaw is equipped with an auto-
matic oiling system. As soon as the motor
is­speeded­up,­the­oil­also­flows­faster­to­
the­chain­bar­(7).
Switch off the device and remove
the battery before carrying out any
maintenance work.
).
).