Idiomas disponibles
Idiomas disponibles
0 601 B11 037 (Australia)
To switch on, slide the switch lock 22 in the direction
of the tool arm. Then press the on/off switch 2 and
hold it depressed.
For safety reasons, the on/off switch of the ma
chine cannot be locked on but must remain de
pressed during operation.
To switch off the machine, release the on/off switch 2.
Working Instructions
Maximum Work Piece Dimensions [mm]
Work Piece Form
Maintenance
Should the machine fail in spite of careful manufactur
ing and testing procedures, have the repairs per
formed by an authorized customer service location for
Bosch electro tools.
For inquiries and spare parts ordering, please include
the 10 digit order number on the nameplate of the ma
chine.
Always keep the machine and the ventilation slits clean
for efficient and safe working. When working with met
al under extreme conditions, conductive dust can be
deposited on the interior of the machine. In such cas
es, frequently blow out the machine through the venti
lation slits and connect by means of a fault current cir
cuit breaker (FI).
The pendulum protective hood must always be able to
move freely and close by itself. Therefore, always keep
the area around the pendulum protective hood clean.
1 609 929 E38 • (05.02) PS
Miter Angle
0 °
45 °
120 Ø
115 Ø
120 x 120
95 x 95
80 x 220
70 x 100
140 x 140
90 x 90
5 MAINTENANCE AND SERVICE
Do not load the machine so heavily that it comes to a
standstill.
Advancing too fast considerably reduces the perfor
mance capabilities of the machine and shortens the
service life of the cutting disk.
The cutting disk becomes very hot while working; do
not take hold of it until it has cooled.
Use only cutting disks that are suitable for the material
to be worked.
Depth stop
As delivered, the depth stop 15 is set so that a new
14" cutting disk does not touch the base plate when
sawing. To compensate for the wear of the cutting
disk, the depth stop can be set deeper.
With the use of a new cutting disk, the depth stop
must then always be set back to the original position.
Always adjust the depth stop so that the
cutting disk does not touch the base plate
when sawing.
Adjusting the Depth Stop
Before all work on the machine, pull the power
plug.
Loosen the locking nut 14 with the open end wrench
11 (13 mm) provided. Swing the tool arm 16 with the
handle 1 to the desired position.
Screw the depth stop 15 in the clockwise or counter
clockwise direction until the bolt head rests on the
housing.
Guide the tool arm 16 slowly upward and tighten the
locking nut 14.
Accessories
Cutting disk . . . . . . . . . . . . . . . . . . . . 2 610 995 082
Disposal
Tool, accessories and packaging should be sorted for
environment friendly recycling.
The plastic components are labeled for categorized re
cycling.
English–6
