Mitsubishi Electric TRANE CITY MULTI TPLFYP EM141 Serie Manual De Instalación página 13

6. Installing the grille
3D i-see Sensor corner panel
Possible installation position 1
(Corner with the air outlet identification marks □/□□□□)
3D i-see Sensor corner panel
Optional wireless signal receiver kit
Prohibited installation position
D
Fig. 6-10
C
D
Fig. 6-11
G E
F
Fig. 6-12
Drain piping of the main unit
A
B
C
E
F
G
F
G
E
A
B
H C D
A
B
3D i-see Sensor corner panel
Possible installation position 2
(Corner with the air outlet identification marks □/□□)
3D i-see Sensor corner panel
Standard installation position (position when
shipped from the factory)
Refrigerant piping of the main unit
Fig. 6-9
6.5. Installation of 3D i-see Sensor corner panel (Fig.
6-9)
6.5.1. Standard position (Fig. 6-10) and position 2 (Fig. 6-11)
• Take the lead wires CN4Z (white, 4-pole) and CN5Y (white, 5-pole) of the 3D i-see
Sensor corner panel 4 from the side of the electrical box on the unit and make
sure to connect them to the connector of the controller board.
• Fix the excess portions of the lead wires using the clamp in the electrical box, mak-
ing sure that there is no slack in the lead wires.
• Put the cover back on the electrical box with 2 screws.
Note:
Make sure wires are not caught in the electrical box cover.
• Adverse procedure of "6.2. Preparing to attach the grille" will be taken for installing
the 3D i-see Sensor corner panel.
• The 3D i-see Sensor corner panel should be fixed onto the grille 1 with screw 3.
6.5.2. Position 1 (Fig. 6-12)
• Take the lead wires CN4Z (white, 4-pole) and CN5Y (white, 5-pole) of the 3D i-see
Sensor corner panel 4 from the side of the electrical box on the unit and make
sure to connect them to the connector of the controller board.
• Route the lead wires through the bell mouth hooks and fix the excess portions of
the lead wires using the clamp in the electrical box, making sure that there is no
slack in the lead wires.
• Put the cover back on the electrical box with 3 screws.
Note:
Make sure wires are not caught in the electrical box cover.
* Adverse procedure of "6.2. Preparing to attach the grille" will be taken for installing
the 3D i-see Sensor corner panel.
• The 3D i-see Sensor corner panel should be fixed onto the grille 1 with screw 3.
[Fig. 6-10] [Fig. 6-11] [Fig. 6-12]
A Controller board CN4Z
B Controller board CN5Y
C 3D i-See sensor corner panel lead wire
D Clamp of electrical box
E Hole of grille (Pass the lead wire.)
F Screw 3
G 3D i-see Sensor corner panel
H Catch of bell mouth
en
12