Husqvarna PG 830 Propane Manual Del Usuario página 17

WARNING:
that have a gradient higher than that marked
on the machine.
1. Start the engine. Refer to
page 16 .
2. Pull out and turn the throttle control to "MIN" or
"MAX" position.
3. Push the product forward across the floor surface.
Use the throttle control to adjust the speed between
"MIN" and "MAX" while you operate the product.
To stop the product
CAUTION:
from the surface when you stop the engine.
The tool plates rotate for a while after the
engine stops. Dust can go into the air and
the surface can become damaged.
CAUTION:
become stationary until the tool plates stop
fully.
2023 - 003 - 04.04.2023
Do not use on surfaces
To start the product on
Do not lift the grinding head
Do not let the product
1. Pull out and turn the throttle control to idle speed for
the engine. Refer to
2. Turn the propane tank valve clockwise until it stops
to stop the propane supply to the engine.
WARNING:
when you touch the propane tank valve.
The propane tank valve can be very
cold.
3. Keep the tool plates against the surface until they
stop fully.
CAUTION:
asphalt, paint or equivalent material,
the product can attach to the adhesive
surface. Immediately after the tool plate
stopped fully, lift up the front of the
grinding head a small distance.
4. Wait until the engine stops. The engine stops when
there is no fuel in the line.
5. Turn the ignition key to the engine stop position.
Rpm for the engine on page 5 .
Use protective gloves
If you grind adhesive
17