Husqvarna PG 830 Propane Manual Del Usuario página 15

• Servicing position of the handle:
To adjust the handle and the handlebar
WARNING:
the handle and the handlebar. Make sure
that the handle and the handlebar locks into
position. The moving parts can cause injury.
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
1. Pull the lock lever (A) on the handle in the direction
of the control panel and hold it in this position.
2. Adjust the handle (B) to an applicable operation
height.
3. Release the lock lever on the handle to lock the
handle position.
2023 - 003 - 04.04.2023
Be careful when you adjust
A
B
4. Loosen the 4 screws (C) on the handlebar.
C
5. Adjust the handlebar (D) to an applicable operation
height.
6. Tighten the 4 screws (E) on the handlebar to lock the
handlebar position.
To connect and disconnect the battery
1. Connect the red cable (+) first and then the black
cable (-). Make sure that the cables are tightly
connected to the battery.
2. Make sure that the strap that holds the battery in
position is correctly installed. The battery cannot
move when the battery is correctly installed.
3. Disconnect the battery in opposite sequence.
To connect and disconnect the propane
tank
CAUTION:
correct propane tank type. An incorrect
propane tank can cause damage to the
product. Refer to
29 .
CAUTION:
tank is in correct position. Do not use the
propane tank upside down.
If the propane tank is connected and the product is not
in operation, close the propane tank valve.
E
D
Make sure to use the
Technical data on page
Make sure that the propane
15