Hilti VC 5-A22-L Manual De Instrucciones Original página 23

All manuals and user guides at all-guides.com
5.2.1 Switching the device on / off
1. To switch on the device, turn the control switch to this position: MAX.
To operate the device for a longer period at reduced suction power, set the control switch to this
position: ECO.
2. To switch off the device, set the control switch to this position: OFF.
5.2.2 Cleaning the filter
1. Switch the appliance on.
2. Hold your hand over the end of the hose.
3. Wait until maximum vacuum pressure is reached.
4. Press the CLEAN button 4-5 times.
5. Switch the appliance off.
5.2.3 After vacuuming
1. Turn the control switch to this position: OFF.
2. Empty the container and clean the appliance by wiping it with a damp cloth.
3. Snap the hose into the hose holder.
4. Stow the nozzles away.
5. Store the vacuum cleaner in a secure, dry place where it is inaccessible to unauthorized users.
◁ CAUTION This vacuum cleaner may be stored only indoors.
6 Care and maintenance of cordless tools
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the cordless tool if signs of damage are found or if parts malfunction. Have the tool
repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
6.1 Changing the filter
1. Switch the device off.
2. Open the two catches.
3. Lift the suction head off the waste material container.
4. To remove the filter frame, turn the filter latch through 180 °.
5. Remove the filter along with the filter frame.
6. Remove all dust from the seal and from the filter frame holder.
7. Set the filter frame on a new filter.
8. Fit the filter frame into the holder for the filter frame.
9. Lock the filter frame into position with the filter latches.
10. Set the suction head on the waste material container and close the two catches.
2202256
*2202256*
Printed: 30.01.2018 | Doc-Nr: PUB / 5397505 / 000 / 00
5
English 17