Idiomas disponibles
Idiomas disponibles
2.6 I Electricity supply connections
• Before any work inside the appliance, you must cut the appliance's electricity supply as there is a risk of
electric shock which may cause material damage, serious injury or even death.
• Incorrectly tightened terminals may cause the terminal box to heat up, which can invalidate the warranty.
• Only a qualified and experienced technician is authorised to carry out cabling work within the appliance or
to replace the power cord.
• The installer must consult the electricity provider if necessary and ensure that the equipment is connected
correctly to an electricity network with impedance under 0.095 ohm.
• The dehumidifier's electrical supply must be provided through a protection and circuit breaking device
(not supplied) complying with the standards and regulations in force in the country in which it is installed.
• The appliance is provided for connection to a general power supply with a TT or TN-S neutral regime.
• Electrical protection: by circuit breaker (D curve, rating to be defined according to the table in §"1.3 I Technical
specifications"), with a suitable dedicated residual-current device (circuit breaker or switch).
• Additional protection may be required during installation to guarantee the overvoltage category II.
• The power supply must correspond to the voltage indicated on the appliance's information plate.
• The power cord must be insulated against any cutting or hot elements that may damage or crush it.
• The appliance must be connected to an earth socket.
• The electrical connection lines must be fixed.
• Use the gland to pass the power cord into the appliance.
• Connect the power cord to the spring connector terminal board inside the appliance, as shown below:
❶
Pull the lever up as far as it will go, then connect the cable.
2.6.1 Terminal block detail
❷
Push the lever back down to its initial position.
X2.6
X2.7
X2.1
X2.2
X2.4
X2.5
X9.1
X9.2
X9.5
X9.6
Filtration pump timer
Filtration pump contactor
Hot water coil kit output
Alarm status output
Remote start/stop input
Pool cover status input
EN
17
