DeWalt D55180 Manual De Instrucciones página 28

CODE POSSIBLE CAUSE
13 Loose belt
14 Pump or motor mount ing nuts are loose
15 Motor overload protection switch has tripped
16 Loose pulley
17 Loose flywheel
18 Carbon build-up in pump
19
Belt to tight
20 Pulley misalignment
21 Extension cord is wrong length or gauge
22 Loose electrical connections
23 Pump oil is low
POSSIBLE SOLUTION
Check belt tension, see Adjusting Belt Tension under
Maintenance.
Torque pump mounting nuts to 6– 8 ft.-lbs. (8.1–10.8 Nm).
Torque motor mounting
(11.3– 13.6 Nm). WARNING: Risk of bursting. Excessive
vibration could weaken the air tank and cause it to rupture
or explode. Mounting screws must be kept tightened.
See Motor Overload under Features.
Tighten pulley set screw, torque to 145–165 in.-lbs.
(16.4– 18.6 Nm).
Tighten flywheel screw,
(20.3– 24.4 Nm).
Contact a D WALT factory service center or a D
E
authorized service center.
Check belt tension, see Adjusting Belt Tension under
Maintenance.
See Motor Pulley/Flywheel
Maintenance.
Check for proper gauge wire and cord length. See
Extension Cords under Installation.
Contact a D WALT factory service center or a D
E
authorized service center.
Add D WALT synthetic compressor oil to pump. See
E
Compressor Pump Oil under Maintenance.
28
bolts to 100– 120 in.-lbs.
torque to 15–18 ft.-lbs.
WALT
E
Alignment under
WALT
E