3 COMMISSIONING
3.1 PARAMETERS RELATED TO THE SAFETY FUNCTIONS MODULE
The parameters of the CFW500 frequency inverter that are directly related to the safety functions
module are presented below.
Symbols used to describe parameter properties:
ro: read only parameter.
„
sy: parameter only visible on HMI when the safety functions module is in the programming mode.
„
3.1.1 Parameters
P0028 - Safety Functions Module
Adjustable
0 = STO Jumper Connector
Range:
1 = CFW500-SFY2
Properties:
ro
Access Groups
READ
via HMI:
Description:
It identifies the safety functions module connected to the frequency inverter, according to
Table 3.1 na página
17.
Name
STO Jumper Connector Frequency inverter without functional safety
CFW500-SFY2
NOTE!
Either the STO jumper connector or the CFW500-SFY2 must be installed on
top of the frequency inverter. Otherwise, the fault message "F0086" will be
displayed by the frequency inverter during power-on.
P0106 - 3
Ramp Time
rd
Adjustable
0.1 to 999.0 s
Range:
Properties:
Access Groups
via HMI:
Description:
It defines the acceleration time from zero to maximum speed (P0134) or deceleration from
maximum speed (P0134) to zero for the 3
Table 3.1: Identification of the safety functions module
Frequency inverter is equipped with a safety functions module
capable of performing STO and SS1-t
Ramp.
rd
Factory
Setting:
Description
Factory
Setting:
Commissioning
-
P0028
0
1
5.0 s
CFW500 | 17