Wayne Dalton Lowe's 8000 Instrucciones De Instalación Y Manual Del Propietario página 6

Weatherstrips (Not Included):
Depending on the size of your door, you may have to cut or trim the weatherstrips
to properly fit into the header and jambs.
NOTICE
IF NAILING PRODUCT AT 40°F, (4.4°C) OR BELOW, PRE-DRILLING IS REQUIRED.
1. For the header, align the weatherstrip with the inside edge of the header and
temporarily secure it to the header with equally spaced nails, approximately 12" to
18" (305 mm - 457 mm) apart.
2. Starting at either side of the jamb, fit the weatherstrip up tight against the
temporarily attached weatherstrip in the header and flush with the inside edge of
the jamb.
3. Temporarily secure the weatherstrip with equally spaced nails. Repeat for other
side. This will keep the bottom door section from falling out of the opening during
installation.
Headroom requirement:
Headroom required is defined as the space needed above the top of the door for
tracks, springs, etc. to allow the door to open properly.
If the door is to be motor operated, 2-1/2" (64 mm) of additional headroom is
required.
TRACK TYPE SPACE NEEDED
12" Radius track 11" (279 mm)
6" Low Headroom 6" (152 mm)
Backroom requirement:
Backroom required is defined as the distance needed from the opening back into
the garage to allow the door to open fully.
DOOR HEIGHT TRACK MANUAL LIFT MOTOR
OPERATED
6'0" to 7'0" 12" Radius 102" (2591 mm) 125" (3175 mm)
6