Wayne Dalton Lowe's 8000 Instrucciones De Instalación Y Manual Del Propietario página 10

INSTALLATION INSTRUCTIONS
Door Installation Instructions
BEFORE INSTALLING YOUR DOOR, BE CERTAIN THAT YOU HAVE READ
AND FOLLOWED ALL OF THE INSTRUCTIONS COVERED IN THE PRE-
INSTALLATION SECTION OF THIS MANUAL. FAILURE TO DO SO MAY
RESULT IN AN IMPROPERLY INSTALLED DOOR.
IMPORTANT: Reference TDS 160 for general garage door terminology at
www.dasma.com.
NOTICE
IF THE DOOR WILL BE EXPOSED TO A SIGNIFICANT AMOUNT OF ROAD SALT,
PAINT THE BOTTOM GALVANIZED STEEL WEATHER RETAINER TO
INHIBIT RUSTING.
1
VERTICAL TRACK ASSEMBLY
NOTE: For clarity, all graphics shown are of the left side, right side will be the
same.
IMPORTANT: The bottom jamb bracket is always the shortest bracket, while the
center jamb bracket is the next tallest.
See Figure 8 and Figure 9 for the following steps.
1a. Locate the flag angle and align the lower Quick Install tab to the vertical
1
track Quick Install feature . Rotate the flag angle 1/4 turn to lock in place
2
IMPORTANT: Each jamb bracket will have a unique ID that starts with "QIJB"
followed by a number. Use this number for the correct jamb bracket outlined
in Table 1. Jamb Bracket Schedule. If not installed correctly, the jamb brackets
won't fit up against the jamb correctly.
1b. Measure the length of the vertical tracks. Using the jamb bracket schedule in
Table 1, determine the placement of the jamb brackets for your door height and
track length. See Figure 8.
1c. To install the jamb brackets, align the Quick Install tab to the vertical track
Quick Install feature . Rotate the jamb bracket 1/4 turn to lock in place
4
IMPORTANT: Mounting flange is toward the back (flat) leg of the track.
1d. Repeat the same process for right hand side.
2
1
Left hand
jamb bracket
4
Figure 8, Left Side Shown
1/4
Turn
3
2nd Set
1st
Left hand
Set
vertical
5
1/4
Turn
Left hand
jamb bracket
Quick install jamb
bracket identification number
Table 1, Jamb Bracket Schedule
Door Track
Height Length
76"
7'0"
(1930 mm)
2
ATTACHING HORIZONTAL TRACK ANGLES
NOTE: For clarity, all graphics shown are of the left side, right side will be the
.
3
same.
NOTE: For larger doors, a full length horizontal track angle may not already be
spot welded to the horizontal track. If the horizontal track angle is not welded, the
horizontal track angle will be installed, as shown.
See Figure 10 for the following steps.
2a. Position the horizontal track angle
2b. Place the Quick Install tabs
of the horizontal track
.
5
the curved end of the track until the alignment hole in the track and angle are
aligned.
2c. Repeat for other side. Set tracks aside.
1
track 1
2
10
Top
hole
Middle
hole
Bottom
hole
Figure 9, Left Side Shown
1st Set 2nd Set
Jamb Hole Jamb Hole
Bracket Position Bracket Position
9 Middle 10 Bottom
, as shown.
1
of the horizontal track angle in the key slot
2
. Using a hammer, tap the horizontal track angle towards
4
Or
2
3
2
4
Figure 10, Left Side Shown
Horizontal Track 3
Angle
Quick Install Tabs 4
3rd Set
Jamb Hole
Bracket Position
N/A
3
Key Slot
Horizontal Track