Wayne Dalton 246060 Instrucciones De Instalación

Wayne Dalton, a division of Overhead Door
Corporation
P.O. Box 67, Mt. Hope, OH 44660
www.Wayne-Dalton.com
1
NOTE: Headroom is defined as the distance from the top of the
Tools Needed:
opening (underside of the header) to the ceiling or an obstruction.
Tape Measure
Marker
NOTE: Top of the vertical tracks can be identified by the quick
install feature or the fully adjustable feature as shown.
Hacksaw
Before starting the installation of the track, lay both vertical tracks
on the floor with the tops of the verticals at the same end.
Select the door model and counterbalance system from the
following list. Once measurements are completed, continue with
the instructions at the end of this step.
WAYNEGUARD™ SERIES 9100, 9400, 9600, 5120 AND 5140
•
•
•
WAYNEMARK™ SERIES 8000, 8100 AND 8200
•
•
•
WAYNEMARK™ 8300 SERIES AND WOOD DOOR MODELS
7101, 7102, 7103, 7104, 7105, 40, 42, 43, 44, 45, 47, 105/110
AND 310/311
•
•
Use a hacksaw to cut the tracks off at the marks. Install the
vertical tracks as described in the installation manual, placing the
cut ends toward the floor.
©Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation
Adjusting the Vertical Track
TorqueMaster Spring Applications (8-1/2" Headroom): Mark
®
both vertical tracks 2-1/2" up from the bottom ends.
Torsion Spring Applications (10" Headroom): Mark both
vertical tracks 2-1/2" up from the bottom ends.
Extension Spring Applications (6" Headroom): Mark both
vertical tracks 2-1/2" up from the bottom ends.
TorqueMaster Spring Applications (6-1/2" Headroom): Mark
®
both vertical tracks 5" up from the bottom ends.
Torsion Spring Applications (10" Headroom): Mark both
vertical tracks 2-1/4" up from the bottom ends.
Extension Spring Applications (6" Headroom): Mark both
vertical tracks 3-3/4" up from the bottom ends.
Torsion Spring Applications (10" Headroom): Mark both
vertical tracks 2-1/4" up from the bottom ends.
Extension Spring Applications (6" Headroom): Mark both
vertical tracks 3-3/4" up from the bottom ends.
Low Headroom Conversion Kit
Installation Instructions
2" Track and 12" Radius Only, Kit # 246060
Part No. 326093
Quick install
feature
Vertical Track Tops
Cut-off
Measurement
based on door
series
Remaining
vertical track
Cut piece of
REV2 05/03/2016
Fully
adjustable
feature
track