Wayne Dalton 8300 Instrucciones De Instalación

This supplemental installation instruction is to be used in conjunction to the main Installation Instruction and Owner's Manual provided with the door. The
instructions included in this document are only those which deviate from the standard installation. All warnings and cautions listed in the main manual are
applicable to this supplemental instruction as well.
P.O. Box 67 Mt. Hope, OH., 44660
WARNING
POTENTIAL DAMAGE TO YOUR TOP SECTION MAY OCCUR IF
INSTALLER DOES NOT INSTALL THE OPERATOR BRACKET
(SUPPLIED BY OTHERS) ONTO THE CONTINUOUS REINFORCEMENT
STRIPS BUILT INSIDE THE SECTION. IT IS VERY IMPORTANT TO
POSITION AND INSTALL THE FASTENERS OF THE OPERATOR
BRACKET (SUPPLIED BY OTHERS) INTO THE CONTINUOUS
REINFORCEMENT STRIPS LOCATED IN ALL CUT DOWN SECTIONS,
AS SHOWN. THIS WILL ENSURE THE OPERATOR BRACKET
FASTENERS (SUPPLIED BY OTHERS) BEING USED ARE GOING
THROUGH THE CONTINUOUS REINFORCEMENT STRIPS INSIDE
THE CUT DOWN SECTION. IT IS EQUALLY IMPORTANT FOR THE
INSTALLER TO NEVER INSTALL THE FASTENERS TO THE OPERATOR
BRACKET (SUPPLIED BY OTHERS) INTO THE INTERIOR SECTION
BACKER STEEL AND NOT INTO THE CONTINUOUS REINFORCEMENT
STRIPS. NOT FOLLOWING THESE INSTRUCTIONS CAN RESULT IN
OPERATOR BRACKET BEING PULLED OFF THE CUT DOWN SECTION.
Part No. 347769
©Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation
Continuous Reinforcement Strips
For Models: 8300, 8500 Cut down
Installation Instructions
www.Wayne-Dalton.com
End stile
Side view of
a cut down
section
REV1 05/03/2016
Interior surface
Typical cut
down section
End stile
Exterior
surface
Typical cut
down section
Continuous
reinforcement
strips
Top of
cut down
section
Interior surface
Exterior
surface
Bottom of
cut down
section
End stile
Continuous
reinforcement
strips
End stile
11/16"
1"
Continuous
1-3/16"
reinforcement
strips
1"
1"
Continuous
1-3/16"
reinforcement
strips
1"
11/16"