Wayne Dalton Lowe's 8000 Instrucciones De Instalación Y Manual Del Propietario página 12

4
ATTACHING HINGES TO SECTIONS
NOTE: Refer to door section identification, located in the pre-installation section
of this manual or refer to Breakdown of Parts.
IMPORTANT: The graduated hinges
stamped on the lower hinge leaf.
IMPORTANT: The #1 graduated hinges
section. The #1 graduated hinges also serves as center hinges on all sections,
except for the top section.
IMPORTANT: The #2 graduated hinges
section .
10
IMPORTANT: The #3 graduated hinges serves as end hinges on the Intermediate
section.
See Figure 13 through Figure 16 for the following steps.
4a. Starting on the left hand side of the bottom section
leaf of the #1 graduated hinge over the holes, located at the top of the end stile
. Attach lower leaf to the end stile with (2) 1/4" - 14 x 5/8" self tapping screws
5
.
6
4b. Repeat same process for the right hand side.
4c. Next, align the lower hinge leaf of the #1 center hinges with the pre-punched
holes at each center stile location(s)
Attach lower hinge leaf to the center stile with (2) 1/4" - 14 x 5/8" self tapping
screws.
IMPORTANT: Once the 1/4" - 14 x 5/8" self tapping screws are snug against
the lower hinge leaves, tighten an additional 1/4 to 1/2 turn to receive maximum
design holding power.
4d. Insert a short stem track roller
8
hinges.
4e. Repeat graduated hinge attachment using the appropriate graduated hinges
for all remaining sections except the top section.
IMPORTANT: When placing short stem track rollers into the #2 graduated end
hinges and higher, the short stem track roller goes into hinge tube
away from section.
2
4
1
6
8
5
Figure 13
8
2
4
5
Figure 14
can be identified by the number
1
serves as end hinges on the bottom
2
serves as end hinges on the Second
3
, align the lower hinge
4
, located at the top of the bottom section.
7
into the hinge tube of the #1 graduated end
furthest
9
2
7
2
2
7
5
3
9
10
8
8
3
5
1
2
3
4
5
6
8
12
1
6
5
Figure 15
2
10
7
Figure 16
Graduated Hinges 6
#1 Graduated 7
Hinges
#2 Graduated 8
Hinges
Bottom Section 9
End Stile 10
2
6
7
8
3
5
1/4" - 14 x 5/8"
Self Tapping
Screws
Center Stile(s)
Short Stem Track
Roller
Hinge Tube
Second Section