Idiomas disponibles
Idiomas disponibles
SYMPTOM
Tool operates but does not drive fasteners fully
Tool operates, but no fastener is driven
Jammed nail
CAUSE
Depth adjust set too shallow
Tool not fi rmly applied to workpiece
Material and fastener length
Damaged or worn driver blade tip
Damaged actuation mechanism
No nails in magazine
Wrong size or angle nails
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver blade
Damaged pusher spring
Wrong size or angle nails
Magazine screws not secured after previous jam clear/inspection
Damaged or worn driver blade
Material and fastener length
Debris in nosepiece
Worn magazine
Damaged pusher spring
13
FIX
Rotate depth adjust to a deeper setting.
Apply adequate force to tool securing it tightly to workpiece See
instruction manual.
If the unit continues to stall (forcing the need to rotate the Stall release
lever) choose the appropriate material and fastener length that is not
too rigorous of an application.
Replace driver/return assembly See authorized service center.
See authorized service center.
Load nails in magazine.
Use only the recommended nails Refer to Nail Specifications.
Clean nose area and watch closely for small pieces of broken nails
stuck in the track.
Clean magazine
Replace magazine See authorized service center.
Replace driver blade See authorized service center.
Replace spring; see authorized service center.
Use only the recommended nails Refer to Nail Specifications.
Make sure to tighten magazine hex bolts with wrench provided.
Replace driver blade See authorized service center.
If the unit continues to stall (forcing the need to rotate the Stall release
lever) choose the appropriate material and fastener length that is not
too rigorous an application.
Clean nose area and watch closely for small pieces of broken nails
stuck in the track.
Replace magazine See authorized service center.
Replace spring; see authorized service center.
