Optional Accessory - DeWalt DCD471 Manual De Instrucciones

Variable Speed Trigger (Fig. A)
Depressing the variable speed trigger
releasing the variable speed trigger turns the tool off. The
variable speed trigger permits speed control—the farther
the trigger is depressed, the higher the speed of the drill.
Forward/Reverse Button (Fig. A)
A forward/reverse button 9
tool. It is located in front of the trigger.
To select forward rotation, release the trigger
the forward/reverse button on the right side of the tool.
To select reverse, depress the forward/reverse button on
the left side of the tool. When changing the position of the
button, be sure the trigger is released.
Installing and Releasing a Bit (Fig. A, E)

WARNING: Always lock off trigger switch
and disconnect tool from power source when
changing acces sories.

WARNING: Always ensure the bit is secure before
starting the tool. A loose bit may eject from tool
causing possible personal injury.

WARNING: The quick release chuck should only
be replaced or repaired by a D
serivce center.
nOTE: The chuck accepts 7/16'' (11.1 mm) hex accessories
and bit tips only.
Place the forward/reverse button
position and remove the battery pack before changing
accessories.
To install a bit or an accessory, fully insert the bit or
accessory into the quick release chuck
accessory is locked into place.
To Remove a bit or an accessory, push the chuck
collar 14 away from the front of the tool. Remove the bit or
accessory. Release the collar.
Fig. E
turns the tool on,
7
determines the direction of the
and depress
7
WALT authorized
e
9 in the lock-off (center)
. The bit or
10
14
Worklight (Fig. A)

CAUTION: Do not stare into worklight. Serious eye
injury could result.
The worklight is activated when the trigger is depressed,
8
and will remain on for a short time after the trigger is
released. If the trigger remains depressed, the worklight will
remain on.
nOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
D WALT Bluetooth® Tool Tag Ready
e
(Fig. A, F)

Optional Accessory


WARNING: Read instruction manual for the D
Bluetooth® Tool Tag.

WARNING: Remove battery from tool before installing
the D WALT Bluetooth® Tool Tag.
e

WARNING: When installing or replacing the D
Bluetooth® Tool Tag, use only the screws provided. Be
sure to securely tighten the screws.
Your tool comes with mounting holes
for installing a D WALT Bluetooth® Tool Tag (DCE041). You
e
will need a cross head bit tip to install the tag. Screw torque
should be between 0.8 and 1.2 Nm (7.1 to 10.6 in-lbs). The
D WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
the D WALT Tool Connect™ app. For proper installation of
e
the D WALT Tool Tag, refer to the D
e
To learn more, visit:
www.D WALT.com/en-us/jobsite-solutions/tool-connect
e
Fig. F
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
English
WALT
e
WALT
e
12 and fasteners 15
WALT Tool Tag manual.
e
15
9