Dometic SPX1200T Instrucciones De Uso página 19

RTX1000/2000, SPX1200
Remote control
➤ Press the
button to increase the required running time of the timer in
10 minute intervals.
The maximum running time is 120 minutes.
➤ To save the value don't press any button for more than 5 seconds.
To reset the timer to 0 minutes, proceed as follows:
➤ Press the
button until the timer shows 120 min.
➤ Press the
button again.
➤ To save the value don't press any button for more than 5 seconds.
8 Display messages
I
NOTE
When you start the vehicle or switch on several consumers at once, the
display text "LO" may briefly appear.
8.1 Control panel warnings
The system control unit has various functions for protecting the device and the
battery. If one of these protective functions has been triggered, this is shown by the
following codes on the display.
Display
Description
indication
LO The battery monitor has
detected low voltage.
LO °C The system has detected
that the ambient
temperature is too low
for operation.
EN
Cause
Connection voltage is too
low. The battery capacity is
not sufficient to operate the
system.
The ambient temperature is
below 5 °C.
Display messages
Remedy
➤ Charge your vehicle
battery.
➤ If the fault occurs again,
contact an authorised
workshop.
➤ Wait until the ambient
temperature has risen
above 5 °C before
switching on the system.
19