Thermador Professional Pro Grand Serie Manual De Instrucciones página 11

Cabinet clearance requirements with OTR
microwave for 30" 5-burner and induction ranges
A 13" (330 mm)
Δ
B 0" (0 mm)
Δ
C min. 30" (762 mm) to non-combustible material
above the cooking surface.
Refer to OTR manufacturer's installation manual
for clearances.
D 18" (457 mm)
E Induction ranges: 0" (0 mm)
All other ranges: 5" (127 mm)
F 30" (762 mm)
G 35⅞" - 36¾" (911 mm - 933 mm)
H 23⅞" (606 mm)
Δ as defined in the "National Fuel Gas Code" (ANSI
Z223.1, Current Edition). Clearances from non-
combustible materials are not part of the ANSI Z21.1
scope and are not certified by CSA. Clearances of less
than 6" (152 mm) should be approved by the local codes
and/or by the local authority having jurisdiction. There is a
possibility to discolor the back wall under certain
cooking conditions.
Side clearances
The dimensions shown are with the included island trim.
¡
A low backguard option is available (purchased
separately).
For an island trim install, the counter surface should
¡
have a cantilever edge meeting the back section of the
island trim.
If an inner wall is used under the cantilever counter top
¡
there should be a ⅛" (3 mm) gap from the rear of the
appliance.
The shaded area behind the appliance indicates the
¡
minimum clearance to combustible surfaces.
Combustible materials cannot be located within this
area with the island trim.
Pro Harmony® ranges
There is a 44⅞" (1140 mm) total clearance
¡
There is a 23⅞" (606 mm) maximum recess depth
¡
Installation requirements en-us
11