Thermador Professional Pro Grand Serie Manual De Instrucciones página 26

en-us Testing the operation
If the water does not flow to the front of the griddle, the
2.
griddle plate needs to be adjusted.
Lift off the griddle plate.
‒
Adjust the two screws under the back of the griddle
‒
plate. Start with one half turn counterclockwise of the
screws.
Replace the griddle plate and check the result.
‒
For further adjustment apply one-quarter turn until the
‒
water slowly flows into the grease tray.
9 Testing the operation
Testing the operation
Check if your unit is working properly after you have
Testing the operation
completed the installation steps.
WARNING
Before you plug in an electrical cord, be sure all controls
are in the OFF position.
Turn on power at the breaker.
1.
The basic settings open automatically.
a
Select a setting with the left < or >.
2.
Change the desired option with the right < or >.
3.
Press ENTER to confirm the selection or SETTINGS to
4.
discard the changes.
The display changes to standby mode.
a
To test the oven select the BAKE mode. See the User
5.
Manual for detailed operating instructions.
Verify that the oven light comes on and the oven begins
6.
to preheat.
9.2 Flame characteristics
The color of the flame tells you if the gas supply is properly adjusted.
Note: Allow the appliance to operate for 4 to 5 minutes before evaluating the flame. Some yellow streaking is normal
during the initial startup.
26
To test the door lock set the SELF CLEAN mode.
7.
Confirm that the door locks when the lock icon appears
in the display.
9.1 Testing the rangetop burners
Each burner must be tested for proper lighting and proper
flame characteristics on the lowest and highest power
level.
Test all rangetop burners for proper ignition.
1.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol ⁠ .
Verify that the igniter/spark module clicks.
‒
Once the air has been purged from the supply lines,
‒
verify that the burner lights within four (4) seconds.
When the burner lights, turn the knob back to the off
position.
If any of the burners do not ignite, do not continue
‒
testing. Call Customer Service.
Test all rangetop burners for flame characteristics on
2.
the lowest setting.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol . Keep it pushed down until the
burner ignites.
Turn the knob quickly to the lowest setting.
‒
Verify that the flame is a minimum height of
‒
approximately ¼" (6 mm).
Verify that the flame is steady. The flame should not
‒
go out, lift or blow off of the burner. It should carry
over, or surround the entire burner.
Verify that the flame is the right color.
‒
→ "Flame characteristics", Page 26 If the flame goes out, does not carry over properly or
‒
is too large, contact Customer Service.
Test all rangetop burners for flame characteristics on
3.
the highest setting.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol . Keep it pushed down until the
burner ignites.
Turn the knob to the highest setting.
‒
Verify that the flame is steady. The flame should not
‒
go out, lift or blow off of the burner. It should carry
over, or surround the entire burner.
Verify that the flame is the right color.
‒
→ "Flame characteristics", Page 26
If the flame burns yellow or does not carry over
‒
properly, contact Customer Service.