Idiomas disponibles
Idiomas disponibles
LSF38 S180 E/R
Compressed air connection
WARNING Air under pressure can cause serious injury
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply when not
►
in use, before making any adjustments to the product, e.g. changing accessories, or when making
repairs.
Never direct air at yourself or anyone else.
►
WARNING Whipping hoses can cause serious injury
Always check for damaged or loose hoses and fittings.
►
Check air pressure:
■
The product is designed for a working pressure (e) of 6–7 bar = 600–700 kPa = 87–102 psig.
■
The air pressure at the tool inlet with the product running must not exceed the maximum operating
pressure 6.3.
■
Blow out the hose before connecting it.
Operation
See also Service instructions
Preparations before using the die grinder
Correct function of die grinder
WARNING Overspeed can result in serious injury or death
The maximum permissible speed as marked on the machine must not be exceeded
►
Testing of the die grinder should only be carried out by professional technicians. The technicians must be
authorized to test this type of tool and to operate a pneumatic system in accordance with national direc-
tives.
■
The free speed of the machine shall be checked every day and whenever the machine has been ser-
viced. This check should be carried out with the grinding equipment detached
■
Use a pressure regulator to avoid excessive air pressure which may cause overspeed
■
Connections and air hose must be in good condition
Mounted wheel and carbide burr
WARNING Air under pressure can cause serious injury
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply when not
►
in use, before making any adjustments to the machine, e.g. changing accessories, or when mak-
ing repairs
WARNING Wrong insert tool can burst and cause serious injury or death
Use insert tool with max operating speed higher or equal to the airgrinder speed
►
Do not use other insert tool than specified by the manufacturer (no cutting off wheels or router
►
bits).
■
Use only recommended sizes and types of abrasives
■
Do not use mounting wheels that are chipped or cracked, or may have been dropped
■
Correct mounting is necessary to prevent injury from broken mounted wheels
■
Ensure the shaft diameter of the accessory is correct for the size of collet
■
Do not mix mm shanks with inch collets and vice versa
■
Observe a min of 10 mm axial grip of the shank
EN
© Atlas Copco Industrial Technique AB - 9836 9632 56
Safety and operating instructions
7
