Idiomas disponibles
Idiomas disponibles
Adjusting for deviations in cut-out value
You may return your torque wrench to
STAHLWILLE for adjustment. You will then receive
the tool back with a new works calibration
certificate.
You may adjust the torque wrench yourself. In this
case, however, STAHLWILLE's accuracy guarantee
is void.
A torque tester of sufficient capacity and accuracy is
required for making readjustments.
For readjustment, each MANOSKOP
with two internal adjuster screws.
These are accessible with an Allen key, size 2 mm,
through two holes in the housing.
The screw which is closest to the end of the handle
is primarily for adjusting the lower end of the scale
range.
is equipped
®
The screw which is closest to the head is primarily
for adjusting the upper end of the scale range.
Each screw has a minor effect on the adjusting
range of the other screw.
To protect the mechanisms from dirt and moisture,
these two holes are plugged.
To adjust the wrench, you will need the torque
tester and an Allen key, size 2 mm.
Maintenance
15
