Idiomas disponibles
Idiomas disponibles
721/30 Quick
➢ Check that the square drive is fitted to the right
side of the torque wrench.
➢ If not, push the square drive out through the upper
side to the right side.
➢ For controlled tightening, switch the ratchet to „R"
or, for uncontrolled loosening of joints, to „L".
➢ Slide the insert over the square drive until it
locates.
Attaching insert tools — 730/5 to
730/65 Quick
➢ Insert the insert tool into the internal square drive
on the face of the head of the wrench. The spring-
loaded locking pin of the insert tool will be
pressed down by the insertion groove.
➢ Slide the insert tool in until it comes to the
endstop. Ensure the locking pin locates in the
hole.
➢ Check to see that the insert tool is properly
attached.
➢ To tighten counter clockwise, turn the insert tool
through 180° before attaching to the torque
wrench.
Operation
9
