Idiomas disponibles
Idiomas disponibles
f)
Start the stirrer drive unit to mix the batch. Press the "WASH" key (c) on the
control panel. The LCD shows the stirrer run icon (I). The appliance beeps
shortly.
g) The batch should be mixed for approx. 1 minute.
h) Run the refrigerating system. Press the "AUTO" key (b) on the control panel.
i)
CAUTION! The "AUTO" key (b) first starts the stirrer drive unit; after 30
seconds, the refrigerating system comes on.
j)
The LCD shows the "ICE CREAM" icon while the batch is processed. The
appliance beeps shortly.
k) When the appliance is running, the stirrer stops automatically once the batch
reaches the density setting.
l)
The appliance restarts processing the batch if two ice cream servings are
dispensed from the refrigerating chamber or 5 minutes of inactivity pass.
m) Ice cream servings are dispensed by pulling the dispenser lever(s) towards you.
The batch stirrer will stop and the dispenser nozzle will release the ice cream
dose.
n) CAUTION! Always have a serving dish or an ice cream waffle ready to dispense
the ice cream cone to.
o) CAUTION! You can dispense more servings of the ice cream while the appliance
is processing the batch. The appliance will switch on the batch processing again
as required.
p) CAUTION! If you need to leave the appliance for several hours without
dispensing any ice cream and with the ice cream batch in the bin(s), start the
pre-cooling before leaving (Model RCSI-17/ RCSI-18). The ice cream batch will
be chilled until you turn off the pre-cooling. Start the PRE-COOLING mode by
pressing the "SET/PRECOOL" key (g).
3.4. Cleaning and maintenance
a)
Before cleaning and when the appliance is not in use, unplug it from the mains.
b)
Only mild cleaning agents intended for surfaces in contact with food shall be
used to clean the appliance.
c)
After each cleaning, dry all components well before the appliance is used
again.
d)
Store the appliance in a dry and cool place, protected from moisture and direct
sunlight.
e)
Do not spray the appliance with a stream of water and do not immerse it in
water.
f)
Ensure that water will not enter through the ventilation ports in the housing.
g)
Clean the ventilation ports with a brush and compressed air.
h)
Regularly inspect the appliance for technical defects and damage.
i)
Use a soft cloth for cleaning.
j)
Do not clean with any sharp and/or metal implements (e.g. a wire brush or a
metal scraper) as these may damage the surface of the appliance.
