Idiomas disponibles
Idiomas disponibles
f)
Install the dispenser levers (12) by inserting them into the holes in the valve
stems (10). Secure the assembly using the cotter pin (13).
g) CAUTION! For model RCSI-16/ RCSI-17: Install the dispenser gasket (15). Do this
by removing the dispenser lid (16) turning it clockwise to detach. Install the
gasket (15) inside of the detached part. Reinstall the detached parts.
h) Attach the resulting assembly to the front panel of the appliance. Do this by
passing the integrated locating pins through the holes in the refrigerating
compartment guard (9). Secure the with the fasteners (14) included.
i)
Install the drip tray by sliding it into its receptacle under the dispenser cluster.
j)
Disassembly is done in reverse order of assembly.
3.3. Operating the appliance
Before operating this appliance, verify the installation process has been correctly
done and connect the power cord plug to a mains outlet. Refer to the appliance
parameters and functions. Turn on the appliance and set the desired parameters
as described below. Start the appliance by turning the power switch (f) ON. When
done, turn the power switch (f) OFF and unplug the appliance from the mains.
3.3.1.
CLEANING THE APPLIANCE COMPONENTS
Before operating the appliance and finishing the operation, always run the cleaning
of the refrigerating bin, the refrigerating compartment and its parts. The
procedure:
a) Fill the refrigerating bin (1) with water.
b) On the control panel, press the refrigerating compartment wash on/off key
("WASH"). The LCD shows the stirrer run icon (I). The appliance beeps shortly.
c)
A correct cleaning cycle needs at least 3 minutes to run.
d) When done cleaning, stop the cleaning mode by switching the refrigerating
compartment wash on/off key ("WASH").
e) Empty the appliance by operating the dispenser lever(s) (12).
f)
Repeat the cleaning steps above 2-3 times.
g) Remove the refrigerating compartment guard (9) and the stirrer (7).
h) Clean the refrigerating compartment guard parts with a dedicated food-
approved detergent.
i)
CAUTION! The temperature of water or the dedicated food-approved
detergent shall not be more than 40°C. Otherwise there will be a risk of
appliance failure.
j)
With the parts dry, coat the sliding surfaces of the stems using a dedicated
food-approved lubricant (see INSTALLING THE APPLIANCE, item C).
k) Reassemble the appliance. When done, the appliance can be operated again.
3.3.2.
LCD ICONS
