Husqvarna FS 305 Manual De Usuario página 12

To remove or replace the cutting blade
WARNING:
diamond blades, let the product become
cool and use protective gloves. Diamond
blades are very hot after use.
1. Make sure that the engine ON/OFF switch is in its
OFF position.
2. Stop the water supply and disconnect the water hose
from the blade guard.
To install a cutting blade on page 10
3. Do the steps in
to remove or replace the cutting blade.
4. Before you operate the product again, start the water
supply and connect the water hose to the blade
guard.
To set the cutting depth indicator
WARNING:
depth wheel when the cutting depth wheel
is not in use.
1. Turn the cutting depth wheel until the cutting blade
slightly touches the ground. Push the lever to lock
the cutting depth wheel.
CAUTION:
blade too quickly. If the cutting blade
hits the surface with force, it can cause
damage to the cutting blade.
12
When you remove
Always lock the cutting
Do not lower the cutting
2. Loosen the screw (A).
3. Rotate the indicator plate until the the position "0" is
at the center of the arrow (B).
4. Tighten the screw (A).
CAUTION:
the cutting depth is correct. The indicator
helps you to get the correct cutting depth
but only gives an indication of the depth
value.
To align the pointer with the cutting
blade
1. Lower the pointer and align the pointer with a line
mark.
2. Make sure that the pointer is aligned with the cutting
blade. If necessary, adjust the guide wheel on the
pointer until it is aligned with the cutting blade.
a) Loosen the nut for the guide wheel.
b) Align the guide wheel with the cutting blade.
c) Tighten the nut for the guide wheel.
To use the correct working technique
WARNING:
when the engine is started.
B
A
Always do a check that
The blade shaft rotates
1919 - 002 - 23.01.2023