Westinghouse iGen2550 Manual Del Usuario página 19

Idiomas disponibles

Idiomas disponibles

OPERATION
A parallel cord or receptacle-mounted parallel cable is
needed for parallel operation. Compatible cords are
sold separately.
Refer to the user manual included with your
parallel cord or receptacle-mounted parallel cable
for installation and operation instructions.
TRANSPORTING
l Turn off the generator.
l Allow the generator to cool a minimum of 30 minutes
before transporting.
l Replace all protective covers on the generator control
panel.
CARE AND MAINTENANCE
WARNING
the spark plug boot (see figure 16) from the
spark plug when performing maintenance on the
generator.
WARNING
items with recommended or equivalent replacement
parts. Using an incorrect or incompatible part might
create a hazard that could result in serious personal
injury.
WARNING
for 30 minutes before performing any maintenance
procedure.
WARNING
engine oil or gasoline. Wear protective clothing
and equipment. Wash all exposed skin with soap
and water. Prolonged skin contact with gasoline
or engine oil may cause severe skin irritation and
other adverse reactions.
Accidental start-up. Disconnect
Replace damaged or worn
Allow hot components to cool
Avoid
skin
contact
l Only use the generator's fixed handle to lift the unit or
attach any load restraints such as ropes or tie-down
straps. DO NOT attempt to lift or secure the generator
by holding onto any of its other components.
l Keep the unit level during transport to minimize the
possibility of fuel leakage or, if possible, drain the fuel
or run the engine until the fuel tank is empty before
transport.
CAUTION
the generator or place it on its side. Fuel or oil can
leak and damage to the generator may occur.
NOTICE
of the product prior to each use. Look for loose
bolts, fluid leaks, and other signs of wear. Replace
all damaged items. For replacement parts or
assistance, contact our customer service team.
To prolong the life of this product, follow the care
and maintenance instructions in this section. Contact
customer service before servicing any recall or warranty
parts.
CLEANING THE GENERATOR
Do not store or operate your generator in dirty, dusty, or
corrosive environments. Do not allow foreign materials
and debris to clog the vents on the unit.
NEVER clean the generator with a garden hose. Water
with
can damage the generator's fuel system and electrical
components. If the unit needs to be cleaned, use a soft
brush and damp cloth to clean the exterior and use low
pressure air (no greater than 25 psi) to clean the vents.
Never use gasoline as a cleaning agent.
Fire hazard. DO NOT up-end
Check the physical condition
English | 19
loading