Emergency Stop; Side Brush - Lavorwash SWL R 1300 Manual De Instrucciones

8.7. PARKING
In case of prolonged stops, in order to ensure the stability of the machine, it is necessary to activate the parking
brake (Item 6 Figure 12) proceeding as follows (Figure 32):
Press the brake pedal (Item 5 Figure 12)
Move the parking brake lever (Item 6 Figure 12) downwards .
To disengage the parking brake, press the brake pedal (Item 5 Figure 12) . The lever will return to the home
position on its own .
NOTE: with the electrical services active, the parking brake is accompanied by a continuous audible signal .
8.8.

EMERGENCY STOP

In case of emergency, it is necessary to:
turn the starter key (Item 1 Figure 12) anti-clockwise until it reaches the "OFF" position.
Engage the parking brake as described in paragraph 8 .7 .
8.9. CENTRAL BRUSH
To start the cleaning operations of the motorsweeper it is always necessary to insert the central brush .
With the engine running:
Use the brush movement selector lever (Item 7 Figure 12) bringing it to single configuration (only central
brush activated, lever down) or combined (all brushes activated, lever up) as shown in Figure 33, pos . A .
Insert the central brush by pushing forward the brush control lever (Item 8 Figure 12) as shown in Figure 33,
pos . B . The brush will lower and start cleaning .
Proceed with the forward movement of the motorsweeper (para . 8 .4) to reach the areas to be cleaned .
To disengage the brush:
Pull back the brush control lever (Item 8 Figure 12) as shown in Figure 33, pos . C . The brush will rise from
the surface .
Use the brush movement selector lever (Item 7 Figure 12) bringing it to a central configuration (brushes
deactivated) as shown in Figure 33, pos . D .

8.10. SIDE BRUSH

To activate the side brush, with the engine running:
Use the brush movement selector lever (Item 7 Figure 12) bringing it to a combined configuration (all brushes
activated, lever up) as shown in Figure 34, pos . A .
Insert the side brush using the side brush switch (Item 10 Figure 12) as shown in Figure 34, pos . B . The brush
lowers to the surface .
If necessary, adjust the rotation speed through the adjustment lever (Item 11 Figure 12) , moving it down to
increase it and up to decrease it (Figure 34, pos . C) .
To disengage the brush:
Disconnect the side brush using the side brush action selector (Item 10 Figure 12) as shown in Figure 34, pos .
D . The brush rises .
If necessary, decrease the rotation speed through the adjustment lever (Item 11 Figure 12) by moving it up
Figure 32
Figure 33
59