Starting With The Web Application; Logging Into The Charger; Starting Setup On The Charger; Overview - Porsche Mobile Charger Connect Manual De Instrucciones

Set up
Hotspot
If integration in a home network is not possible, the
charger can activate a hotspot and use this to es-
tablish a connection to the Web Application of the
charger.
e
To establish a hotspot, click Activate hotspot.
Once a hotspot has been established, the
appears in the status bar.
Information
If you use an Android system, you may need to con-
firm separately that the connection has been estab-
lished, so that a hotspot connection can be estab-
lished.
Adapt charging current
If no energy manager is available in the home net-
work, the maximum permitted charging current for
the charger can be set here.
The displayed maximum value is determined by the
types of cable that are connected.
e
Set the charging current to the maximum value
available in the mains supply used for the
charger. Use Plus and Minus to do this.
g Refer to chapter "Charging current limiting" on
page 71.
Device protection
To prevent an unauthorised vehicle from being con-
nected to the charger, a PIN prompt can be set up.
1. To activate the PIN prompt, select On.
2. Enter a 4-digit PIN and confirm.
68
3. Enter the PIN again and confirm.
�� Activation of the PIN prompt is confirmed.
Completing installation
e
Using the Review, check the settings you en-
tered and complete the installation.
symbol

Starting with the web application

Before the charger and the Web Application can be
used for daily use, the first step is to set up the
charger. A connection must then be established be-
tween the device (PC, tablet or smartphone) and the
charger.
Requirements for initial start-up in the web
application
The following information should be available for the
first application of the Web Application :
–
Access data letter of the Porsche Mobile Charger
Connect for logging on to the Web Application of
the charger
–
Access data for your home network
–
Access data for your user profile (to link it with
your Porsche ID)
The web application supports the following browsers:
– Google Chrome version 57 or later (recommen-
ded)
– Mozilla Firefox version 52 or later (recommen-
ded)
– Microsoft Internet Explorer version 11 or later
– Microsoft Edge
– Apple Safari version 10 or later

Logging into the charger

Information
You will find the data for logging into the charger
in the enclosed letter containing access data. The se-
curity field contains the access codes (PIN and PUK).
This field has special ink covering these codes.
The codes are only visible when this field is mois-
tened in running water.
Do not rub or scratch the field while moistening it, as
the codes could also be damaged.
b The charger is switched on.
b The letter containing access data is to hand.
1. Find out the PIN from the letter. To do so, mois-
ten the security field to make the PIN visible.
2. Enter the PIN.

Starting setup on the charger

The charger is set up using the setup wizard, which
guides you through the steps involved in installation.
Setup must be complete before the charger can be
used correctly.
g Refer to the Porsche Mobile Charger Connect Oper-
ating Manual for details about setting up the charger.

Overview

The Web Application offers more extensive setting
options than the charger.