Malfunctions - Porsche Mobile Charger Connect Manual De Instrucciones

Malfunctions

Fig. 43: Display of malfunctions
Situation
The display (screen, status LEDs, Power button) has stopped working com-
pletely.
The display is blank, the status LEDs do not change colour and the Power button
lights up red.
Restricted operation or charging not possible (message on display).
A Status LEDs light up red
B Error message and cause
C Remedy
In the event of faults or malfunctions, the charger
shows a corresponding message on the display. The
status LEDs and the Power button light up red.
The message shows details of the error, information
about the cause and a remedial measure.
e
Follow the instructions provided for the remedial
measure.
NOTICE
Damage to the charger
Recommended action
e
Disconnect the charger from the mains supply and have it replaced.
e
Have the domestic installation checked by a qualified electrician.
e
The charger is overheated. Disconnect the charger from the mains supply
and allow it to cool down slowly on its own.
e
If the error persists, have the charger replaced.
e
Make sure that the supply cable and vehicle cable are connected to the con-
trol unit at the correct side and are plugged into the connections correctly.
e
Make sure that the charger is within the permitted temperature range.
g Refer to chapter "Technical Data" on page 86.
e
Acknowledge any error message that appears.
e
Restart the charger. Press the Power button for at least 10 seconds to
restart.
e
If a fault persists or recurs, disconnect the
charger from the mains supply and contact a
qualified electrician. Porsche recommends that
you use a certified Porsche service partner.
The following overview contains recommendations
for dealing with malfunctions that restrict or prevent
charging of the vehicle.
Malfunctions
81