Product Identification; Product Description - CAMPAGNOLA SL23 Manual De Uso Y Mantenimiento

3.1

Product identification

The identification CE plate/label (Figure 1) is applied to each machine/tool.
The model, serial number and year of manufacture are shown on the manufacturer's CE plate and affixed on the ma-
chine. The CE plate is applied on the machine/tool and shows the data and symbols described below:
1) Conformity marking according to directive 2006/42/EC.
2) Company name and complete address of the manufacturer.
3) The compulsory requirement for all personnel in charge of use and/or maintenance of the tool to read the use and
maintenance manual.
4) Tool designation.
5) Type of tool - Type/code designation of the tool.
6) Serial number.
7) Year of manufacture, i.e. the year in which the manufacturing process was concluded.
8) Information pursuant to "WEEE" Directive 2012/19/EU: Electric and electronic waste may contain hazardous sub-
stances for the environment and human health and therefore must not be disposed of with domestic waste, they
must be collected in dedicated collection centres.
9) Tool supply voltage (only for battery powered electrically supplied tools).
IMPORTANT!
To properly identify the tool, refer to the type, serial number and year of manufacture shown on the identification
plate and quote them to Campagnola Srl for any service request.
IMPORTANT!
The CE marking is unique and it certifies the conformity of the product with the machinery directive and the other
applicable directives in compliance with the conditions prescribed and shown in this manual.
In case of a "composite" machine/tool, a CE plate/label which identifies the type of tool (e.g. ATRA.xxxx) com-
posing the composite machine/tool is affixed to the product.
IMPORTANT!
The customer is in charge of checking the integrity of the CE plate/label.
The user must replace the CE and/or warning plates which become illegible due to wear.
It is strictly forbidden to remove the plates/labels on the machine/tool. Campagnola S.r.l declines any responsibility
on the safety of the machine/tool in case of non-compliance with this prohibition.
DIRECTIVE 2012/19/EU ONLY APPLIES TO ELECTRIC AND ELECTRONIC TOOLS AND/OR
DEVICES (EEE).
THEREFORE, EVEN IF THE CE PLATE/LABEL SHOWS THE
SYMBOL OF A CROSSED OUT BIN, THIS DIRECTIVE DOES NOT APPLY TO PNEUMATIC
PRODUCTS NOT EQUIPPED WITH AN EEE.
3.2

Product description

The product is designed for cutting or pruning branches with a maximum diameter of 23 mm, depending on the hardness
of the wood, in orchards, vineyards, etc. It is battery-operated and consists of: a fixed blade, a moving blade, a lithium
battery, a battery charger, a toolbox and other components. Simple to use, it is 8/10 times more efficient than manual
shears. The quality of pruning is significantly better than pruning by hand.
Use and maintenance manual – Instructions
Original instructions Rev. : 00 Date 01/07/2022
Figure 1
Page 23