Black and Decker BDX2700 Manual De Instrucciones página 9

Connect Spray
4
Wand to Spray
Gun
Thread the spray wand into
the end of the spray gun.
Release Air from
7
System
Release all air from
pump and high pressure
hose by depressing
trigger until a steady
stream of water is present.
Approximately 30 seconds.
Verify the Choke
10
Pin is Pulled Out
to the CLOSED
Position
The Choke Pin has been
preset by the factory to be
in the CLOSED Position.
See Label #10 on the
side of the engine.
WARNING: This Guide is not a substitute for reading the instruction manual. User must
read and understand operator's manual before using this product.
All manuals and user guides at all-guides.com
Connect QC
5
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
Verify the fuel
8
Valve is turned to
the OPEN
Position
The Fuel Valve has been
preset by the factory to
be in the OPEN position.
See Label #8 on the
side of the engine.
Pull the Recoil
11
Starter Grip
Pull the
recoil starter grip to
start the engine.
See Label #11 on the
side of the engine.
9 - ENG
Turn Water
6
faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
Verify the Engine
9
Switch is turned
to the ON
Position
See Label #9 on the
side of the engine.
Push the Choke
12
Pin to the OPEN
Position
Gradually move the Choke
Pin to the OPEN Position
after engine starts.
See Label #12 on the
side of the engine.