Black and Decker BDX2700 Manual De Instrucciones página 17

All manuals and user guides at all-guides.com
WARNING: Risk of fire hazard.
Always disconnect, spark plug wire,
let the engine cool and release all
water pressure before performing
any maintenance or repair. The
engine contains flammable fuel. Do
not smoke or work near open flames
while performing maintenance.
To ensure efficient operation and
longer life of your pressure washer, a
routine maintenance schedule should
be prepared and followed. If the
pressure washer is used in unusual
conditions, such as high-temperatures
or dusty conditions, more fre quent
maintenance checks will be required.
ENGINE
Consult the Engine Owners Manual for
the man u fac tur er's recommendations
for any and all maintenance. NOTE:
The engine drain plug is located at the
rear of the unit.
PUMP
The pump was filled with oil at the
factory. The pump on this unit is
maintenance free and requires no oil
to be added or changed. If there is a
problem with the pump contact us at
www.power-washer.us
CONNECTIONS
Connections on pressure washer
hoses, gun and spray wand should be
cleaned regularly and lubricated with
light oil or lithium grease to prevent
leakage and damage to the o-rings.
NOzzLE CLEANING (fIG. 24)
If the nozzle becomes
with foreign materials, such as dirt,
excessive pressure may develop.
the nozzle becomes partially clogged
or restricted, the pump pressure will
pulsate. Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
1. Shut off the pressure washer and
turn off the water supply.
2. Pull trigger on gun handle to
relieve any water pressure.
3. Disconnect the spray wand from
the gun.
4. Remove the high-pressure nozzle
(K) from the spray wand. Remove
any obstructions with the nozzle
cleaning
backflush with clean water.
24
5. Direct water supply (N) into spray
wand
particles for 30 seconds.
6. Reassemble the nozzle to the
wand.
7. Reconnect spray wand to gun and
turn on water supply.
8. Start pressure washer and place
spray wand into high pressure
setting to test.
CLEAN ThE WATER INLET
fILTER (fIG. 20)
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove filter by grasping end and
removing it from water inlet of
pump.
2. Clean filter by flushing it with water
clogged
on both sides.
3. Re-insert filter into water inlet of
If
pump. NOTE: Cone side faces out.
NOTE: Do not operate the pressure
washer without filter properly installed.
ENGINE
Consult the Engine Owners Manual
for manufacturer's recommendations
for storage.
17 - ENG
tool
provided
and
K
N
K
to backflush loosened
STOrAGE