Calibrating The Electronic Vernier Caliper/Gauge Arm; Calibrating The Sbm V655 - Sicam SBM V655 Manual Original

11.3.3 Calibrating the electronic vernier caliper/
gauge arm
i
Follow the instructions shown on the monitor.
1. Start calibration in the calibration menu. Press <F4>
and <OK>.
2. Set the vernier caliper (B) to the rest position and
press <OK>.
3. Extend the vernier caliper (B) to 200 mm, enter this
value and press <OK>.
4. Set the gauge arm (A) to the rest position, use a rule
to measure the "MAX" distance, enter the value and
press <OK>.
5. Set the gauge arm (A) to minimum position with
respect to the vernier caliper (B), use a rule to
measure the "MIN" distance , enter the value and
press <OK>.
6. Clamp a test wheel in position (ideally 13" or 14").
7. Enter the wheel diameter with <F4> and press <OK>.
8. Apply the vernier caliper (B) to the rim flange and
press <OK>.
"
Calibration of vernier caliper and gauge arm completed
Sicam srl società unipersonale
All manuals and user guides at all-guides.com
11.3.4
i
1. Attach a motor vehicle wheel of medium size
2. Press <F3> and <OK>.
3. Enter the wheel data and confirm with <OK>.
4. Press <START>.
5. Enter any balance weight between 40 g and 120 g
6. Attach a balance weight of the value entered to the
7. Press <START>.
8. Turn the wheel until the balance weight is in the
9. Remove the balance weight from the inner side
10. Press <START>.
11. Turn the wheel such that the weight is in the
12. Press <OK>.
"
i
Maintenance | SBM V655 | 45

Calibrating the SBM V655

Follow the instructions shown on the monitor.
(e. g. width 5.5", diameter 14") and in very good
condition to the flange.
« Calibration is started.
« Measurement commences.
and confirm with <OK>.
inner side of the wheel.
« Measurement commences.
12 o'clock position.
of the wheel and attach it to the outer side
(12 o'clock).
« Measurement commences.
6 o'clock position.
This completes calibration.
The calibration made is permanently stored
automatically.
en
|
656 234 2010-11-22