Adjusting The Laser; Inserting/Replacing Laser Batteries; General Information; Switching On And Off - Parkside PTBM 400 A1 Traducción Del Manual De Instrucciones Original

Adjusting the laser

G
Caution! - Laser beam. Do not look
into the beam. Turn your head
away or close your eyes to prevent
looking into the laser beam. Dan-
ger of eye injury!
To adjust the laser, use a section of
wood that you no longer need.
1. Spot-drill the clamped workpiece. Do
not make any further changes to the
position of the workpiece until the laser
has been adjusted.
2. Turn the laser (33) on at the on/off switch.
3. Set the laser cross to where the workpi-
ece has been spot-drilled by turning the
two controllers (18).
Inserting/replacing
H
laser batteries
1. Turn the laser off.
2. Open the battery compartment of the
laser (17) by sliding the lock upwards
and opening the compartment.
3. Insert the batteries according to the po-
larity indicated on the cover.
4. Close and lock the battery compartment
(17).

General Information

The feed rate and spindle speed are
decisive for the service life of the bit.
- The cutting speed is determined by the
speed of the drill spindle and by the
diameter of the bit.
- In principle, therefore, the larger the
bit diameter, the lower the speed that
should be selected.
- For workpieces of greater strength, the
cutting pressure must be higher.
- Repeated withdrawal of the bit enables
easier chip removal.
- Chip removal is especially difficult in
deep holes. Reduce the feed rate and
speed in this case.
- To avoid excessive wear on the cutting
surface of the bit, for drill holes over
8.0 mm in diameter you should first
drill with a bit with a smaller diameter.

Switching on and off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
Caution! Fold the protective
device (23) down before you
switch on the machine.
Switching on:
1. Fold open the cover (26) of the emer-
gency stop switch (24).
2. Press the On switch (28).
3. Close the cover (26) of the emergency
stop switch (24).
Switching off:
1. Fold open the cover (26) of the emer-
gency stop switch (24).
2. Press the Off switch (27).
3. Close the cover (26) of the emergency
stop switch (24).
Emergency stop:
Press the emergency stop button (24).
After actuating the emergency stop,
press the on switch (28) to start the
device again.
GB MT
69