Transport And Storage; Product Overview; Intended Use - Hilti DSH 600 Manual

▶ Always use an undamaged clamping flange of the correct diameter which fits the cutting disc used.
The correctly fitting clamping flange supports the cutting disc and thus reduces the possibility of disc
breakage.
▶ Guide the product smoothly and do not apply lateral pressure to the cutting disc. Always bring the cutting
disc into contact with the workpiece at right angles. Don't attempt to alter the line of cut by applying
lateral pressure or by bending the cutting disc while cutting is in progress.
▶ Wear protective gloves when changing the cutting disc as the disc will get hot during use.
▶ Abrasive cutting discs which are used for wet cutting must be used up the same day as long periods of
exposure to moisture have a negative effect on the strength of the disc.
▶ Observe the expiry date for resin-bonded cutting discs and don't use the discs after this date.

2.6 Transport and storage

▶ Switch the product off before transporting it.
▶ Remove the cutting disc from the product after use. The cutting disc may suffer damage during transport
with the disc fitted.
▶ Handle the cutting disc carefully and store it in accordance with the manufacturer's instructions.
▶ Always store and transport the product in an upright position, not lying on its side.
▶ Do not transport the product by crane.
▶ Store the product in a secure place when not in use. Products which are not in use must be stored in a
dry, high place or locked away out of reach of children.
▶ When laying the product down, make sure that it stands securely.
▶ After use, allow the product to cool down before packing it away or placing a cover over it.
▶ Store gasoline and oil in a well-ventilated room in fuel containers that comply with regulations.
3 Description

3.1 Product overview

3.1.1 Gasoline-powered cut-off saw
Guard
@
Water supply
;
Water connection
=
Front grip
%
Throttle trigger
&
Rear grip
(
Recoil starter pull handle
)
Fuel tank cap
+
Primer bulb
§
Fuel level indicator
/
Choke lever (DSH 600)
:
Footplate
∙
Exhaust discharge with spark filter
$
Cutting disc
£
Clamping screw
|
Clamping flange
¡

3.2 Intended use

The product described is a gasoline-powered cut-off saw for the wet or dry cutting of asphalt, mineral
construction materials or metals using diamond cutting discs or abrasive cutting discs.
The saw is not suitable for use in environments where there is risk of fire or explosion.
3.3 Possible misuse
▶ "Shoveling" with the gasoline-powered saw is not permissible.
Printed: 30.03.2017 | Doc-Nr: PUB / 5341995 / 000 / 00
All manuals and user guides at all-guides.com
1
Q
W
W
E
R
T
Z
U
I
O
P
Ü
[
Rating plate
Throttle safety grip (DSH 600)
Safety grip with integrated brake actuation
(DSH 600-X)
Start/stop switch with integrated half-
throttle lock
Water cock
Spark plug connector
Cleaning screw for water nozzle
Grip for guard adjustment
Curved water distributor with integrated
water nozzles
Hole for locking pin for changing cutting
discs
Saw arm
Pump cover
Air filter cover
English 25