Remove The Solenoid - Kohler K-10673 Guía De Mantenimiento

Cap
DC Sensor
Connector
Retaining Nut
Solenoid
Connector
Pin
Diaphragm

Remove the Solenoid

Close the control stop valve.
NOTE: If the unit has not flushed since the stop valve was closed,
the inlet arm may still be pressurized. Use the manual flush button
to release pressure.
Using a 3/32" hex wrench, remove the setscrew from the cap.
Remove the cap by lifting from the valve body.
Pull the two connectors apart to disconnect the DC sensor
connector from the solenoid connector.
Temporarily store the cap and DC sensor assembly in a safe
place.
Using an adjustable wrench, turn the solenoid assembly
counterclockwise to remove the solenoid assembly from the valve
body.
1108709-5-C
All manuals and user guides at all-guides.com
Setscrew
Solenoid
Assembly
Spring
Valve Body
10
O-Ring
Piston
Cover
Piston
Kohler Co.