Step 9: Placing And Leveling The Range - Thermador PROFESSIONAL PRO HARMONY PRG305PH Manual Del Usuario

To Reinstall the Oven Door
To Check Door Fit and Operation
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. Do not force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. The range must be level for proper alignment of the
oven doors, see "STEP 9: Placing and Leveling the
Range".
3. If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
Installation Instructions
1. Hold the door firmly in both
hands.
2. Hold the door at a 30°
angle from the closed position.
Insert hinges centered evenly
into the hinge slots. The hinges
will securely hook into the slots
when properly installed. DO NOT
force, bend or twist the door.
3. Open door fully to expose
hinges, levers, and slots.
4. Flip the hinge forward and
down until seated on the bracket.
A screwdriver may be required
to carefully push the clip back.
5. Close and open the door
slowly to ensure it is correctly
and securely in place.
Figure 19: Door Install
4. If door or handle appears slightly tilted, you may adjust
the hinge receiver by rotating the large Torx-head
screw located directly below the hinge receiver with a
T-20 Torx driver. Rotate each screw respective to its
side and direction the door needs to be adjusted
(Figure 20).
Figure 20: Hinge Receiver Adjustment Screw
STEP 9: Placing and Leveling
the Range
Leveling Leg Adjustment
CAUTION
The top edges of the range's side panels must be on the
same or higher level as the adjacent countertop. If the
range is operated while at a lower height relative to the
adjacent cabinet, the cabinet could be exposed to
excessive temperatures, causing damage to the cabinet
and countertop (see Figure 22).
For proper performance, the range must be level. This is
especially important for all products that have the griddle
feature. Priority should be placed on ensuring that the oven
cavities are also level for optimum cooking performance.
1. Measure the countertop heights first with a tape
measure and add an additional 1/16'' - 1/8'' (2-3 mm).
Adjust the legs accordingly prior to pushing the range
back to its final location.
English | 19 |