Malfunctions And Troubleshooting - Nouvag HighSurg 30 Instrucciones De Uso

HighSurg 30
10

Malfunctions and troubleshooting

Malfunction
Control unit is
Device is not
not switched on
operational
Power connection not
established
Incorrect operating voltage Check the mains voltage
Faulty fuse
Motor not switched on
Motor does not run
Incorrect motor active
Motor not connected
Handpiece or contra angle
not correctly assembled
No irrigation fluid for Peristaltic pump not
switched on
instrument
Tubing set incorrectly
inserted
Tubing set clogged/crusted
matter visible
Bottle with sodium chloride
solution not ventilated
Tubing set is dripping
Roller clamp of tubing
set is closed
Pedal is not operational Pedal not connected
Incorrect operation
If a fault cannot be rectified, please contact your supplier or an authorized service centre. The addresses are provided on
the last page of the operating instructions.
HighSurg 30 Operating Instructions, Ref. 31666, V24/16
All manuals and user guides at all-guides.com
Cause
Set the
to "I"
Connect the control unit to the
mains power supply
Replace the fuse
Switch on the motor using the
treadplate
Switching to the other motor,
using the Vario pedal
Connect the motor cable to the
control unit
Press the handpiece firmly onto
the electronic motor until it
clicks into position and check
that it is secure by moving it
slightly in the opposite direction.
Switch on the peristaltic pump
Insert tubing set correctly (note
the direction)
Replace the tubing set
Open the ventilation filter at the
drip chamber
Replace the tubing set
Open roller clamp all the way
Connect the pedal to the control
unit
Check operating instructions
Solution
7.1 Switching the device on and
power switch "I/O"
off
6.2 Connection to the power
supply
6.2 Connection to the power
supply
9.1 Replacing the control unit fuse
7.8 Operation using the Vario
pedal
7.8 Operation using the Vario
pedal
5.0 Device overview
6.2 Connection to the power
supply
6.3 Device preparation
7.8 Operation using the Vario
pedal
6.3 Device preparation
6.3 Device preparation
6.3 Device preparation
6.3 Device preparation
6.3 Device preparation
6.3 Device preparation
7.8 Operation using the Vario
pedal
Refer to operating
instructions
EN
27