Nouvag HighSurg 30 Instrucciones De Uso página 52

Parameter Level 1
Group/Parameter
Software/Version
Hardware/Serial number MB
Date-Time/Date format US
Date-Time/Date
Date-Time/Time
Battery/Voltage
Language/0 = DE, 1 = EN
Backlight/brightness (0. .10)
Program/Number of programs
for 50,000 rpm motor
Program/Number of programs
for 80,000 rpm motor
Program/Number of programs
for 16,000 rpm motor
Program/Power on at last
program
Operating hours/Control Unit
Operating hours/Motor 1
Operating hours/Motor 2
Operating hours/Pump
Error memory/ 1 – 8
Handpiece activation
Handpiece existing/HP 01
Handpiece existing/HP 02
Handpiece existing/HP 03
Handpiece existing/HP 05
Handpiece existing/HP 06
Handpiece existing/HP 07
Handpiece existing/HP 08
Handpiece existing/HP 09
Handpiece existing/HP 10
Handpiece existing/HP 11
Handpiece existing/HP 12
Handpiece existing/HP 13
Handpiece existing/HP 14
Handpiece existing/HP 15
18
All manuals and user guides at all-guides.com
Rights Factory
read VX.XX
read
92XXXXXXX
read/write no
read/write –
read/write –
read e.g. 3120 mV
read/write 1
read/write 9
read/write 10
read/write 6
read/write 1
Read/write Yes
read XX:XX:XX
read XX:XX:XX
read XX:XX:XX
read XX:XX:XX
read X
Name of handpiece Choice
on display
1 : 5 yes/no
1 : 3 yes/no
1 : 2 yes/no
Com.Saw yes/no
Osc.Saw yes/no
Sag.Saw yes/no
Dermatome yes/no
Kirschner Hp yes/no
Tattoo Hp yes/no
Cont.Shaver yes/no
Osc.Shaver yes/no
Jacobs Chuck yes/no
Perforator yes/no
Craniotome Yes/no
Definition
Shows current software version
Shows serial number of the main board
Set to US Date format
Change current date
Change current time
State of charge of battery
(Capacity about 3100 mV, Low 1800 mV)
Change display language between German and English
Display brightness, variable: 0, ... , 10
Number of activated Programs: 3, ... , 10
Number of activated Programs: 1, ... , 7
Number of activated Programs: 1, ... , 3
No: Display of Motor 1 with Program 1
Yes: Display of the last used program/motor
Shows operating hours of HighSurg 30
Shows operating hours of motor 1
Shows operating hours of motor 2
Shows operating hours of pump
8 Error messages in chronological order.
For the list of error codes please refer to chapter 10.
Factory Definition
default
yes Deselect handpieces that do not belong
to your product range by switching to
yes
"no". This will later shorten the scrolling
list for "Handpieces". Otherwise you will
yes
later have to scroll down the complete
yes
list of available handpieces, each time
you select a handpiece.
yes
yes
Because HP 04, 1:1 is permanently active,
it's not listed in this table.
yes
yes
yes
yes
yes
no
no
no
HighSurg 30 Operating Instructions, Ref. 31666, V24/16
HighSurg 30