Sawing With The Adaptation Table - Festool CARVEX PSC 400 EB Manual De Instrucciones

The angle table WT-PS 400 is used for sawing inte-
rior and exterior angles up to 45° and pipes.
Dust extraction is not possible when sawing
with the angle table!
Installing the angle table
X
Remove the saw table [1-10], (see chapter
Changing saw table).
X
Position the angle table against the saw table
support.
X
Close the change lever [1-8].
Ensure that the angle table is firmly seated in the
guide.
Setting the angle
X
Turn the adjusting wheel [8-1] to set the desired
angle.
You can set the values -45°, 0° and +45° using the
scale [8-2].
Angle table position
Picture [9] Angle, interior angle
Picture [10] Angle with support exten-
sion
Picture [11] Exterior angle, pipes
9
All manuals and user guides at all-guides.com
8-1
8-2
Application
10
11
WARNING
Sawing cutting depths
Risk of injury
X
Select the saw blade length and cutting depth so
that the saw blade always stays in the work-
piece.
L For 90° cuts, we recommend setting the angle
table to a small negative degree value to guar-
antee stable running.

Sawing with the adaptation table

WARNING
Risk of injury
X
Always disconnect the battery pack before in-
stalling the adaption table!
The adaptation table ADT-PS 400 is used for fitting
your jigsaw on the Festool guide rail and the circle
cutter KS-PS 400.
Installing the adaptation table
X
Remove the saw table [1-10].
15