Operation; Water - Haier HLPW028BXW Manual Del Usuario

ERROR CODE
FA
(Water Level
Sensor Error)
F2
(Water Level is
Too High)

OPERATION

PROBLEM
Washer does
not run

WATER

PROBLEM
Water flow is
slow or filling
takes a long
time
Water
temperature is
too warm or
cold
DESCRIPTION
The washer has detected
water level sensor errors.
The washer has detected
higher than normal water
levels, automatic draining
has not resolved the issue.
POSSIBLE CAUSE(S)
There is no electrical power
going to the washer.
Circuit breaker tripped or
fuse blown
The washer is overloaded or
the wash load is not
balanced.
The Heavy Duty or Whites
cycle was selected.
Delay start has been
selected.
The washer lid is open.
POSSIBLE CAUSE(S)
Hose filter screens on the
water inlet valves may be
clogged.
Water inlet faucets are not
fully turned on.
Water fill hose is kinked.
There is no water supply to
the house or the water
pressure is too low.
Water heater temperature
is not set correctly.
POSSIBLE CAUSE AND
SOLUTION
Call service center at
1-877-337-3639.
Call service center at
1-877-337-3639.
SOLUTION
Plug the power cord into a
grounded 3 prong outlet.
Reset/Turn on circuit breaker
or replace fuse.
Laundry may need to be
removed or redistributed to
rebalance the load.
The washer pauses during
cycles for the laundry to soak.
When the soak time ends, the
washer will restart
automatically.
Cancel the delay start.
Close the washer lid.
SOLUTION
Disconnect hoses from inlet
valves and clean the screens.
Make sure that the water
faucets are fully turned on.
Make sure the water hoses are
not tangled, kinked, or
pinched.
Check another faucet in the
house to make sure that
household water pressure is
adequate.
Hot water needs to be at a
temperature of at least 120°F
-140°F (49°C - 60°C).
32